Q. A realtor told this to my fiance on a house. Rather than going ahead and paying an inspector, what does this mean? What does "new plumbing" entail?

A. Well it depends on WHAT he told her....if he said new plumbing then he probably means new water AND drain lines......that would be a repipe of both systems.....but if he said new kitchen lines or bathroom lines then he meant just that......find out EXACTLY what her told her....NOW after saying that i would STILL get the inspector bacause he doesnt just check plumbing...he looks at the WHOLE house.....the framing and support.....electrical.....plumbing....foundation......roof......walls....EVERYTHING....so i would definitely get the inspector that way u will know everything thats needs fixing and not just the plumbing

(No Chosen Answer)

Q. I once saw in a magazine that you can add plumbing without cutting into the slab. Yet I have not been able to find anything else on it. It was in a contractors magazine. If anyone knows anything please let me know.

A. They make rear discharge toilets that would allow the drain to be run thru a wall to the main. Don't know but they may make a set-in-place toilet and pump unit that would provide an above-the-slab forced main to the main. Check with a quality plumbing supply house. The next answer mentions a sewer sump pump but that is a big job [think a 3' dia. hole about 3' below the slab for the sump] and would involve cutting some concrete. but it would allow you to locally set fixtures and pump up to the sewer main, so it wouldn't mean cutting a long line.

(No Chosen Answer)

Q. I have a shower and the plumbing runs up from the floor. On the wall the containing the plumbing, on the opposite side, is an electrical switch and outlet. What is the minimum safe distance between the electrical lines and the plumbing so that a plumbing leak doesn't result in someone being killed or hurt?

A. There is no NEC (national electric code) restriction on this. The supply pipes and electric wire and box could actually all be on the same stud.

(No Chosen Answer)

Q. I'd like to add decorative exposed copper plumbing to my bathroom (for a funky industrial feel) but I have no resources to reference! Does anyone know where I can find some? Thanks!

A. I've seen the look you're after and it's pretty flash here a couple of sites, although one is in black and white you'll get the idea of what is possible using exposed copper plumbing. www.vintageplumbing.com/ This other site has a few of the fittings you'll need to get it down. http://www.bizrate.com/plumbingsupplies/products__keyword--plumbing+copper+cross.html I tried answering your mail but it came back? anyway it's right now. Edit: Now this one isn't working, you're going to have to copy and paste the URL to get there, I have no idea whats happening here.

(No Chosen Answer)

Q. I have a problem. I always flush my cig butts down the toilet and now there is a plumbing problem in my apt building. They will be turning off the hot water for repairs. Will It get traced back to me?

A. Only cold water it routed to the toilet. Flushing drains the water to the sewage pipe. Hot or cold bears nothing to this, its all sewage.

(No Chosen Answer)

Q. I am just now starting to finish my basement. When we built 2 yrs ago we had it prepped for a bathroom and a wet bar. We are starting at the bathroom, do we put the walls up first and have the plumber out before the walls go up? Do we want the sink/tub/toilet there for him or is that not necessary? I guess my question is what steps do I take and in what order? Thanks in Advance!!

A. Do your framing for the walls, then call the plumber to have him install the pipes that will be hidden inside the wall. The bathtub etc can also be installed at the same time. Install the water faucets after the room is finished/walls installed so they will not be accidentally damaged during construction. Hint: Tape the drains & cover the toilet while you work so construction material, nails etc won't fall into the drain. 1 nail lodged in the drain, add some hair/sludge equals a real problem to fix later.

(No Chosen Answer)

Q. I cut a chase in sub-floor to change plumbing from a tub to a shower, i covered sub-floor with 1/4 durarock,then cement for a solid base,morter mix to slope floor towards drain i was then going to install a membrane when customers tile installer said it had to be removed and replaced that i installed it incorrectly. It was my understanding that after the membrane he was to install thinset over membrane and then tile ? can someone please help answer my questions i still am not sure if i made any mistakes i was trying to ensure a good base for durable longevity

A. The membrane goes behind the durock, and under the mortar bed, the idea is that the membrane holds all the water in and is the last defense between the wood and durock/mortar bed, thinset wont bond to the membrane, it is meant to be attached to concrete of some form whether durock or the mortar bed...putting a membrane in between will keep the the thinset from attaching properly and in turn would cause a horrible tile job, you will need to rip out everything you did and start over from the frame work, dont be surprised if this customer doesn't call you back for anymore work. i would suggest hiring a sub-contractor who knows how to do the job properly and eat the cost if you want to maintain any kind of reputation. and dont take jobs that you aren't 100% sure you know how to do. i dont suggest shoving the membrane under the mortar bed or making an attempt to "make" it work...if its not done right and it leaks you can face a law suit for future water damage because of poor installation of membrane. It has to be done right.

(No Chosen Answer)

Q. I had the plumbers in here on Friday to install a cutoff valve in hopes of getting a new refrigerator soon. I just had a "floating" vinyl floor installed 6 months ago. Good Armstrong high quality flooring. When the plumber moved my old peg-legged (no rollers on this baby) refrigerator he tore and "X" 4 inch by 4 inch section of my new flooring. They want to patch it. I say replace it. If it had been 4 or 5 years old I could live with a patch. I saved a long time to get this flooring installed. I paid cash for the materials and installation. What would you do?? Well good news!!! The plumbing company has agreed to replace my flooring. The President of the Company came out himself and said "if it was my house I would want it replaced too". End of story - problem solved. Thank you all for your answers. And oh Bob, nanananana!!!

A. Of course the contractors will tell you to patch it, they don't have to live with the floor. Is it too much to ask that the appliance be moved properly, is this his first job. A responsible contractor carries a set of furniture, appliance movers to avoid this situation. There is no way to patch this floor without leaving an obvious defect. Demand a new floor and if they don't respond, call the plumbers association and the better business bureau. That's the cost of doing business carelessly. If he broke your sink would you let him patch it, if it's a real business, he has liability insurance. Once you agree to a patch you are relinquishing your claim

(No Chosen Answer)